Nitobond® EP

Nitobond EP is based on solvent free epoxy resins containing pigments and fine fillers. It is supplied as a two part material in preweighed quantities for ready onsite mixing and use. It is supplied as a two-part material in pre-weighed quantities ready for onsite mixing and use.

Coloured components – white base and green hardener – provide visual evidence that adequate mixing is achieved.

• Can be applied to dry or damp surfaces
• High mechanical strength
• Good positive adhesion
• Can be applied where a substrate/repair barrier is required
• Standard and slow set grades

Aquaproof Anchoring Systems is authorised project Super stockist and brushbond authorised Fosroc applicator for Fosroc Chemicals(India) in Pune, Maharashtra and a leading dealer for construction chemicals.

Limitations:
Nitobond EP should not be applied when the temperature is below 100C.

For bonding new cementitious materials to existing cementitious surfaces. For use on horizontal surfaces and on vertical surfaces where mortar or concrete can be supported by formwork. Ideal for extensions and repairs to structural concrete in buildings, loading bays, bridges, roads, bonded or granolithic floor toppings etc.

Nitobond EP can be applied by brush.

• More overlay time:Enables to place the concrete upto 6 hrs after applying Nitobond EP, without risk of delamination.
• High bond strength : Bond strength is more than the tensile strength of good quality concrete.
• Barrier coat: Acts as a ‘barrier coat’ to the migration of
  chloride ions from host concrete.

Approximately 2.6 m2/litre.

Actual coverage will depend upon the texture and porosity of the surface being covered.

Available in 1/2, 1 and 4 litre industrial packs.