Reebaklens is a combination of acid based material, corrosion inhibitors and dispersing agents and is supplied as a clear blue solution.


Rapid action: Safe with metals (except zinc and galvanised steel), wood, glass, plastic and rubber. No corrosive action. Penetrates oil and grease.

Aquaproof Anchoring Systems is authorised project Super stockist and brushbond authorised Fosroc applicator for Fosroc Chemicals(India) in Pune, Maharashtra and a leading dealer for construction chemicals.

For the removal of mortar and plaster runs, droppings and stains from brickwork and concrete surfaces. Also for removal of hardened concrete from tools, machinery and equipment, or rust and mill scale from steelwork. Suitable for etching of concrete floors and surfaces prior to application surface coatings.

Reebaklens cleaning agent should be diluted with water and applied at the rate of approximately 1 litre per 2 sq.m. The dilution will depend upon the condition of the floors and the degree of etching required, but normally it will be between 1 : 2 and 1:4. When the action has finished, wash down thoroughly with clean water.



Reebaklens is available in 1,5 and 20 litre containers.

Cleaning brickwork :

A small trial area should be cleaned first to determine the most suitable Reebaklens cleaning agent dilution. Pre-wet the brickwork, then using a sponge, rub the affected areas with a solution of Reebaklens cleaning agent and water. Strength of the solution required will vary but should be between 1:1 and 1:4.

Cleaning small tools :

Use Reebaklens as a dip. The tools should be soaked overnight, then taken out and washed with clean water to remove all loosely adhering materials. Care should be taken to avoid prolonged contact between Reebaklens and zinc or aluminium parts of tools